Píobaire, An, Volume 1, Issue 7, Page 5

Píobaire, An, Volume 1, Issue 7, Page 5
Favourite | Share | Feedback


periodical Publisher
Na Píobairí Uilleann
periodical Editor
Chairman, NPU
periodical Title
Píobaire, An
volume Number
issue Content
(59) QUILLS9FIG. 1 BASS1 - _ __Lenght-5 inches Diameter- mm Bore-7rnmCut and trim above node.Clean inside of quill with wire.FIG. 2fine 4 xedhernp,for distance of inch.FIG 3--.---.--.----.-. - .-,...-____ -I )t ii , fbn aape r.Finish With fine sandpaper.-.-.Using a single edged razor blade,m ake a cut. 3/4 inch fromtop of cane and at a slight angle as shown.The cut .canbcstbe made by uSing the blade with a see-saw rnotion.The depth of cutshould be a little less than half the diameter of the cane.C H :.:: ELBring the blade back a Shade and bend down to lift the tongue.Run the blade dowh to binding.t,.IcL (.in- - -..-L. . . ___. LEDLengh. -4 inches Diameter-7min Bore-.6mmCut node off con plete1y at wide end.Cl an inside.Plug wide end with ccork and seaiin wax.Taper end and bind a ahove.Cut should be madeinch from top with depth of approx.1/3 diameter of canc.PIG. 7 TENORL _ -,.Lenght 3 inches Diameter -6 Bore-5mmAs baritone but cut is made inch from en.d and to depth of thediameter of cane.NOTESLift t. ngue and snap it up and down a few times.Roll it between palr sto get correct rotind.Continue with these operations until the quillspe ks.1 o tune put, two rounds of binding on quil.l.To harj, 1vanchi.fld n up th tongu or cut . piece off th hct.tc m(tapered)To n1rtai g o c do m the tc ig r pitt d ]ob y -t.h tI r r f
issue Number
page Number
periodical Author
issue Publication Date

Píobaire, An, Volume 1, Issue 7

Related Keywords